Beyond FD-SOI and FinFETs, important SOI-based developments in advanced device architectures including nanowires (NW), gate all around (GAA) and other FET structures shared the spotlight at IEDM 2014 (15-17 December in San Francisco). IEDM is the world’s showcase for the most important applied research breakthroughs in transistors and electronics technology.
Here in Part 2 of ASN’s IEDM coverage, we’ll cover future device architectures. In Part 1, we had a rundown of the top SOI-based advanced CMOS papers. In Part 3 we’ll look at MEMS, NEMS, sensors and more.
Summaries culled from the abstracts follow.
16.2: Dual-Channel CMOS Co-Integration with Si Channel NFET and Strained-SiGe Channel PFET in Nanowire Device Architecture Featuring 15nm Gate Length
P. Nguyen et al (Leti, ST, Soitec)
Omega-gate CMOS nanowire transistors, with a diameter of 12nm and gate length of 15nm. The NFETs have a silicon channel while the PFETs have a SiGe channel. The germanium (Ge) content is estimated to be 30%. (Courtesy: Leti, ST, Soitec at IEDM
14, Paper 16.2)
The researchers have fabricated the first hybrid channel omega-gate CMOS nanowire (NW) with strained SiGe-channel (cSiGe) p-FETs and Si-channel n-FET. An optimized process flow based on the Ge enrichment technique results in a +135% hole mobility enhancement at long gate lengths compared to Si. Effectiveness of cSiGe channel is also evidenced for ultra-scaled p-FET NW (LG=15 nm) with +90% ION current improvement. -oriented NW is shown to be the best candidate to improve drive current under compressive strain. In this work, the strain is measured by using precession electron diffraction with a 1nm spatial resolution. Furthermore, they show that hybrid integration reduces the delay of CMOS ring oscillator (FO=3) by 50% at VDD=0.9V. Finally, they demonstrate the most aggressively scaled hybrid CMOS NWs reported to date with NW width and gate length down to 7nm and 11nm, while maintaining high drive current (687µA/µm for p-FET and 647µA/µm for n-FET) with low leakage current and excellent short-channel-control (DIBL<50mV/V).
20.5: Study of the Piezoresistive Properties of NMOS and PMOS Omega-Gate SOI Nanowire Transistors: Scalability Effects and High Stress Level
J. Pelloux-Prayer et al (Leti, Soitec, Tokyo Tech)
The researchers present a comprehensive study of piezoresistive properties of aggressively scaled MOSFET devices. For the first time, the evolution of the piezoresistive coefficients with scaled dimensions is presented (gate length down to 20nm and channel width down to 8nm), and from the low to high stress regime (above 1GPa). They show that the downscaling of geometrical parameters doesn’t allow the use of the conventional definition of piezoresistivity tensor elements. The obtained results give a comprehensive insight on strain engineering ability in aggressively scaled CMOS technology.
20.3: Direct Observation of Self-heating in III-V Gate-all-around Nanowire MOSFETs
S.H. Shin et al (Purdue U)
Multi-gate devices, such as, FinFET, Gate-all-around transistors (GAA-FET) improve 3D electrostatic control of the channel, but the corresponding increase in self-heating may compromise both performance and reliability. Although the self-heating effect (SHE) of FinFET appears significant, but tolerable, the same may not be true for GAA geometry, especially in quasi-ballistic regime where hot spots and non-classical heat-dissipation pathways may lead to localized damage. The existing reports of the SHE on the SOI, FinFET or GAA-FET have so far relied either on indirect electrical measurements with inherent temporal delays, or on optical infra-red (λ>1.5μm ) imaging that cannot resolve deep submicron features. As a result, it has so far been impossible to resolve the spatio-temporal features of SHE fully. In this paper, the researchers develop an ultra-fast, high resolution thermo-reflectance (TR) imaging technique to (i) directly observe the local temperature rise of GAA-FET with different number of nanowires (NW)(ii) characterize/interpret the time constants of heating and cooling through high resolution transient measurements, (iii) identify critical paths for heat dissipation, and (iv) detect in-situ time-dependent breakdown of individual NW.
9.6: In-situ Doped and Tensilely Stained Ge Junctionless Gate-all-around nFETs on SOI Featuring Ion = 828µA/µm, Ion/Ioff ~ 1×105, DIBL= 16-54 mV/V, and 1.4X External Strain Enhancement
I-H. Wong et al (Taiwan U)
In-situ CVD doping and laser annealing can reach [P] and tensile strain as high as 2×1020 cm-3 and 0.37%. Junctionless Ge gate-all-around nFETs with 9 nm-Wfin and 0.8 nm-EOT achieves the record high Ion of 828 µA/µm. The Ion enhancement of ~40% is achieved under the tensile strain of 0.25%.
27.6: Flexible High-performance Nonvolatile Memory by Transferring GAA Silicon Nanowire SONOS onto a Plastic Substrate
J.-M. Choi et al (KAIST, NASA)
Flexible nonvolatile memory is demonstrated with excellent memory properties comparable to the traditional wafer-based rigid type of memory. This achievement is realized through the transfer of an ultrathin film consisting of single crystalline silicon nanowire (SiNW) gate-all-around (GAA) SONOS memory devices onto a plastic substrate from a host silicon wafer.
13.2: High Ion/Ioff Ge-source Ultrathin Body Strained-SOI Tunnel FETs – Impact of Channel Strain, MOS Interfaces and Back Gate on the Electrical Properties
M. Kim et al (U Tokyo)
The researchers demonstrated Ge/strained-Si hetero-junction TFETs with in-situ B doped Ge. The increase in channel strain and optimization of PMA have successfully realized high performance of steep SSmin below 30 mV/dec and large Ion/Ioff ratio over 3×107.
13.3: Comprehensive Performance Re-assessment of TFETs with a Novel Design by Gate and Source Engineering from Device/Circuit Perspective
Q. Huang et al (Peking U)
In this paper, a novel TFET design, called Pocket-mSTFET, is proposed and experimentally demonstrated by evaluating the performance from device metrics to circuit implementation for low-power SoC applications. For the first time, from a circuit design perspective, TFETs performance in terms of ION, IOFF, subthreshold slope (SS), output behavior, capacitance, delay, noise and gain are experimentally benchmarked and also compared with MOSFET. By gate and source engineering without area penalty, the compatibly-fabricated Pocket-mSTFET on SOI substrate shows superior performance with the minimum SS of 29mV/dec at 300K, high ION (~20μA/μm) and large ION/IOFF ratio (~108) at 0.6V. Circuit-level implementation based on Pocket-mSTFET also shows significant improvement on energy efficiency and power reduction at VDD of 0.4V, which indicates great potential of this TFET design for low-power digital and analog applications.
13.4: A Schottky-Barrier Silicon FinFET with 6.0 mV/dec Subthreshold Slope over 5 Decades of Current
J. Zhang et al (EPFL)
The researchers demonstrate a steep subthreshold slope silicon FinFET with Schottky source/drain. The device shows a minimal SS of 3.4 mV/dec and an average SS of 6.0 mV/dec over 5 decades of current swing. Ultra-low leakage floor of 0.06 pA/μm is also achieved with high Ion/Ioff ratio of 107.
26.2: Thin-Film Heterojunction Field-Effect Transistors for Ultimate Voltage Scaling and Low-Temperature Large-Area Fabrication of Active-Matrix Backplanes
B. Hekmatshoar et al (IBM)
Heterojunction field-effect thin-film transistors with crystalline Si channels and gate regions comprised of hydrogenated amorphous silicon or organic materials are demonstrated. The HJFET devices are processed at 200ºC and room temperature, respectively; and exhibit operation voltages below 1V, subthreshold slopes of 70-100mV/dec and off currents as low as 25 fA/um.
26.7 Performance Enhancement of a Novel P-type Junctionless Transistor Using a Hybrid Poly-Si Fin Channel for 3D IC Applications
Y.-C. Cheng et al (National Tsing Hua U, National Chiao Tung U)
The hybrid fin poly-Si channel junctionless field-effect transistors (FET) are fabricated first. This novel devices show stable temperature/reliability characteristics, and excellent electrical performances in terms of steep SS (64mV/dec), high Ion/Ioff (>107) and small DIBL (3mV/V). The devices are highly promising for future further scaling and 3D stacked ICs applications.
35.1: A Physics-based Compact Model for FETs from Diffusive to Ballistic Carrier Transport Regimes
S. Rakhejaet al (MIT, Purdue U)
The virtual source (VS) model provides a simple, physical description of transistors that operate in the quasi-ballistic regime. Through comparisons to measured data, key device parameters can be extracted. The VS model suffers from three limitations: i) it is restricted to short channels, ii) the transition between linear and saturation regions is treated empirically, and iii) the injection velocity cannot be predicted, it must be extracted by fitting the model to measured data. This paper discusses a new model, which uses only a few physical parameters and is fully consistent with the VS model. The new model: i) describes both short and long channel devices, ii) provides a description of the current at any drain voltage without empirical fitting, and iii) predicts the injection velocity (device on-current). The accuracy of the model is demonstrated by comparison with measured data for III-V HEMTs and ETSOI Si MOSFETs.
~ ~ ~
This is the 2nd post in a 3-part series. Part 1 (click here to read it) of ASN’s IEDM ’14 coverage gave a rundown of the top FD-SOI and SOI-FinFET papers. Part 3 (click here to read it) covers SOI-based MEMS, NEMS, sensors and more.